Change Blade And New Mat Not Cutting Through Cricut

Read this replacing knife blade help article.

Change blade and new mat not cutting through cricut.

Make sure to replace the blade housing back into your machine correctly. Rotary blade for cricut maker. Once clean perform a test cut. Today we will be talking about why your cricut will not cut correctly.

Insert the new blade into the housing. If the blade and housing were already free from debris proceed to step 3. You don t have to buy new mats and new blades just to get great cuts on your cricut and i ll show you how to cut better and save material. If the blade and housing are already free from debris or cleaning it did not help proceed to step 3.

It could be a problem with the specific material that you are trying to cut. Cricut tm goes through the motions but isn t cutting 1 make sure the blade is inserted correctly into the assembly. Knife blade for cricut maker. Both of these can cause cut issues.

The magnet in the housing will hold the new blade in place. Remove the protective cover from the new blade. Ensure that you are using a cricut brand blade. Then inspect the blade and blade housing and remove any debris that may be stuck to the blade or lodged in the blade housing.

You can also change the blade used to cut a material or the number of times it will cut. The small knife end should be sticking out not the cone point end. Believe it or not this is a common problem so even if you are not a beginner you may need to troubleshoot in the future. Try using a new blade and mat.

Attempt cutting a different material such as copy paper at the appropriate setting for that material. Inspect the blade and blade housing for and remove any debris that may be stuck to the blade or may have worked its way up inside the blade housing preventing the blade from swiveling properly. Five tips to fix cricut cutting problems so you get fine clean cuts every time. Replace the blade housing into your machine.

You have your project all set up. Then inspect the blade and blade housing and remove any debris that may be stuck to the blade or lodged in the blade housing.